Configuring Remote Services
Use the Remote Services page to configure communication to the Xerox datacenter, and to process received updates.
Note:If your network uses an HTTP or HTTPS proxy server to access the internet, ensure that the correct configuration or remote services will not operate as required. For details, refer to
Proxy Server.
To configure Remote Services:
1. In the Embedded Web Server, click Properties > General Setup > Remote Services.
2. To enable Remote Services, for Policies and Schedule, click Configure. For details, refer to Policies and Schedule. 3. To send or receive data between the device and the Xerox datacenter, click Check Now.
4. When the check is complete, the Receiving Status area displays an updated status message:
• No new update is available
• New update is available to manually install
• New update is available to install on <date/time>
• New update is available; installation is paused
• New update has been submitted for installation
5. If an update is available, for Available Update, select an option:
•Cancel
•Pause
•Resume
•Install Immediately
6. The Sending Status area shows the last date that device diagnostic fault information was sent to Xerox. To disable the automatic sending of diagnostic information to Xerox, refer to Policies and Schedule.