Administrator Tools Mode

Xerox : Overview and Settings : Administrator Overview : Administrator Tools Mode

The following summary describes the various options that you can set while logged in as administrator. You can set these options from the Machine Status > Tools tab on the press User Interface (UI).

When you press the Tools tab while in the Administrator mode, the following features are available for selection:

• Cleaning the Fuser Assembly - If needed, run this image quality procedure to clean and remove dry ink/toner debris that may appear on the back side of prints.

• DFA Finisher Profile - If the press includes a third-party, DFA inline finishing devices, this feature is enabled to create a profile of the finisher and add, edit, and delete attributes.

• Simple Image Quality Adjustment (SIQA) Tools - This is a set of procedures used to correct and adjust alignment, density uniformity, and image quality transfer on prints. For detailed information and procedures, refer to the SIQA chapter.

• Tools - Select the Tools tab on the UI to access other areas where you can set system functions and security settings, including the following:

• System Settings: For details, refer to System Settings.

• Setup & Adjustment: For details, refer to Setup & Calibration.

• Accounting: For details, refer to Accounting.

• Authentication/Security Settings: For details, refer to Authentication/Security Settings.

Note: Use the scroll buttons on the screens to view the entire list of options.