Replacing the Booklet Staple Cartridge for Saddle Stitching

Note: Ensure that the press is not running before performing this procedure.

Note: This procedure is applicable only or the PR Booklet Maker Finisher.

1. Open the finisher front cover.

2. Pull out the Saddle Stitch Unit 3 toward you until it stops.

3. While holding the tabs on the staple cartridge, pull out the cartridge to remove it.

Note: There are two booklet staple cartridges provided. Check the message to see which cartridge needs replacing.

4. While holding the tabs on the new staple cartridge, push in the cartridge until it seats.

Note: Make sure that the marks are aligned.

5. Push the Saddle Stitch Unit 3 gently into the finisher until it stops.

6. Close the finisher front cover.